Chevrolet Camaro Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(555)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(555)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Chevrolet Camaro Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1991 Chevrolet CamaroV8-5.0LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1968 Chevrolet CamaroV8-5.3LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2000 Chevrolet CamaroV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1969 Chevrolet CamaroV8-5.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1996 Chevrolet CamaroV8-5.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1970 Chevrolet CamaroV8-6.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1989 Chevrolet CamaroV8-5.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2019 Chevrolet CamaroV6-3.6LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Chevrolet Camaro Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(555)

Rating Summary
526
13
1
3
12
526
13
1
3
12

Joshua

27 years of experience
709 reviews
Joshua
27 years of experience
Chevrolet Camaro V8-5.7L - Steering Shaft Replacement (Steering Column To Steering Box) - Concord, California
Terrific work.... best mechanic I have ever had !!!

Clifton

30 years of experience
40 reviews
Clifton
30 years of experience
Chevrolet Camaro V6-3.6L - Canister Purge Solenoid - Columbia, South Carolina
Thanks

Chet

41 years of experience
493 reviews
Chet
41 years of experience
Chevrolet Camaro V6-3.6L - Battery - Chula Vista, California
Chet arrived on time and finished in time. he was friendly, very knowledgeable and detail oriented.

Daniel

11 years of experience
52 reviews
Daniel
11 years of experience
Chevrolet Camaro V6-3.6L - Car is making a noise Inspection - Elk Grove, California
Kind, knowledgeable guy who genuinely wants the best result for the customer and their car.

Excellent Rating

(555)

Rating Summary
526
13
1
3
12
526
13
1
3
12
Number of Chevrolet Camaro services completed
6105+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1600+
experts on our platform

Recent articles & questions

The Best Used Cars to Buy If You’re an Electrician
As As an electrician, you have to haul around wiring, tools and equipment, and tons of supplies. You can’t get by with a small used car, or even a big one. What you probably need is a good used cargo...
Symptoms of a Bad or Failing AC Receiver Dryer
If you see signs of refrigerant leakage, hear rattling noises, or smell mold coming from the AC, you may have to replace the AC receiver dryer.
P3475 OBD-II Trouble Code: Cylinder 10 Deactivation/Intake Valve Control Circuit Low
P3475 means a malfunction in engine cylinder number 10 in which the vehicle will be unable to run in lower modes and may cause lower fuel efficiency.

Air Bag Light Illuminated 2006 Hyundai Elantra

Hi - resetting the Air Bag light (https://www.yourmechanic.com/question/my-service-air-bag-warning-came-on-should-i-worry-by-iamisaiah) will require, at a minimum, a scan/reset tool capable of accessing the Supplemental Restraint System (SRS) which monitors the air bag status. If the problem was a temporary disconnect at the air...

Can you pass emissions with a turbocharged car with odb-2 if it did not originally come with a turbocharger?

Can you pass emissions with a newly turbocharged car that has ODB-2 that does not come with a turbocharger from the factory? It is illegal to modify any factory installed emissions system on a motor vehicle. Adding a turbocharger...

2007 rendezvous cxl where is fuel filter located at

This vehicle does not have a regular fuel filter but has a fuel strainer on the bottom of the fuel pump assembly inside the fuel tank.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com