Chevrolet Aveo5 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(67)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(67)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Chevrolet Aveo5 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2011 Chevrolet Aveo5L4-1.6LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2008 Chevrolet Aveo5L4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2007 Chevrolet Aveo5L4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2009 Chevrolet Aveo5L4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2006 Chevrolet Aveo5L4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2010 Chevrolet Aveo5L4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Chevrolet Aveo5 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(67)

Rating Summary
63
1
0
1
2
63
1
0
1
2

Russell

24 years of experience
356 reviews
Russell
24 years of experience
Chevrolet Aveo5 L4-1.6L - Cooling/Radiator Fan Motor - Portland, Oregon
I am very satisfied with how Russell repaired my daughter's car. I am in another state and I am very happy with booking through Yourmechanic and the professional way in which Russell handled the repair.

Miguel

35 years of experience
258 reviews
Miguel
35 years of experience
Chevrolet Aveo5 L4-1.6L - Car is not starting - Miami, Florida
Miguel was a pleasure. He communicated very well and diminished any possibility for concern. I learned a great deal from Miguel. He even took the time to explain what he was checking and how I would identify what needed to be serviced. I now have a reliable and permanent "doctor" for my car.

Jason

23 years of experience
190 reviews
Jason
23 years of experience
Chevrolet Aveo5 L4-1.6L - Car Battery Replacement - Nashville, Tennessee
Jason recently came and changed my transmission fluid and battery. He cleaned my battery connections and now my car accelerates and shifts gears in the same smooth manner I remember when I bought the car. Highly recommend Jason for your car trouble needs!

Zave

17 years of experience
41 reviews
Zave
17 years of experience
Chevrolet Aveo5 L4-1.6L - Water Pump - Charlotte, North Carolina
Zave was on time for the appointment and pinpointed the exact problem with ease. Having mechanics in my family, he is very knowledgeable and the experience shows. 8 would definitely work with Zave again and I appreciate him getting to the root of the problem.

Excellent Rating

(67)

Rating Summary
63
1
0
1
2
63
1
0
1
2
Number of Chevrolet Aveo5 services completed
737+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1600+
experts on our platform

Recent articles & questions

P2441 OBD-II Trouble Code: Secondary Air Injection System Switching Valve Stuck Closed Bank 1
P2441 P2441 code definition Secondary Air Injection System Switching Valve Stuck Closed Bank 1 What the P2441 code means P2441 is an OBD-II code for the engine control module (ECM) detecting no exhaust pulse while monitoring the exhaust pressure sensor...
P3446 OBD-II Trouble Code: Cylinder 6 Exhaust Valve Control Performance
P3446 means certain cylinders were shut down during specific driving conditions due to low oil pressure, faulty lifters or varied sensors.
B2100 OBD-II Trouble Code: Driver's Door Key Cylinder Switch Failure
B2100 trouble code means a failure in the driver's door key cylinder, often due to a defective driver's door key cylinder switch.

How do I view Gauge mode?

In the Uplevel Message Center, there is a feature called Gauge mode. Gauge mode helpfully shows some of your vehicle's stats as a graphic. To view the options in Gauge mode. Use the Up or Down arrow keys on your...

I was driving and all of a sudden my car made a loud horrible screeching sound and it continues as long as the engine is running

The noise sounds like you have a belt pulley that is seized. You will need to either start the vehicle and look for the pulley to component that is not turning or will need to remove the serpentine belt and...

Fuel inefficiencies

In order to check your fuel economy you will need to fill your fuel tank completely and zero your trip meter and drive vehicle until you use at least a half tank of fuel and then fill the tank and...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com