Cadillac Brougham Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Cadillac Brougham Car Battery Replacement is $315 with $175 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1990 Cadillac BroughamV8-5.7L	Service typeCar Battery Replacement	Estimate$504.68	Shop/Dealer Price$598.40 - $865.39
1992 Cadillac BroughamV8-5.7L	Service typeCar Battery Replacement	Estimate$495.67	Shop/Dealer Price$586.30 - $850.97
1992 Cadillac BroughamV8-5.0L	Service typeCar Battery Replacement	Estimate$495.67	Shop/Dealer Price$586.34 - $851.04
1990 Cadillac BroughamV8-5.0L	Service typeCar Battery Replacement	Estimate$495.67	Shop/Dealer Price$586.34 - $851.04
1991 Cadillac BroughamV8-5.0L	Service typeCar Battery Replacement	Estimate$495.67	Shop/Dealer Price$588.92 - $855.55
1991 Cadillac BroughamV8-5.7L	Service typeCar Battery Replacement	Estimate$495.67	Shop/Dealer Price$586.59 - $851.47

Show example Cadillac Brougham Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Cadillac mechanics

Real customer reviews from Cadillac owners like you.

Excellent Rating

(23)

Rating Summary

23

0

0

0

0

23

0

0

0

0

SEE REVIEWS NEAR ME

James

31 years of experience

1039 reviews

James

31 years of experience

by Kyle

Cadillac Brougham V8-5.0L - Power Steering Belt - Lake Mary, Florida

James was extremely knowledgeable and extremely polite; it was clear from the start that he takes pride in doing a thorough and near-perfect job. It was a privilege to have him work on my car.

Christian

11 years of experience

36 reviews

Request Christian

Christian

11 years of experience

Request Christian

by John

Cadillac Brougham V8-5.0L - Spark Plugs - Fort Lauderdale, Florida

Outstanding young man with extreme talent to work on my 30 plus year Cadillac. Friendly and knowledgeable about cars, polite and professional. Thank you Christian, hope you will be able to continue to repair my 1991 Cadillac Brougham

Brandon

21 years of experience

773 reviews

Request Brandon

Brandon

21 years of experience

Request Brandon

by Kyle

Cadillac Brougham V8-5.0L - Alternator - Lake Mary, Florida

He's quick efficient and well informed.

Claud

9 years of experience

640 reviews

Claud

9 years of experience

by Clara

Cadillac Brougham V8-5.0L - Wipers are not working - Detroit, Michigan

Arrived on time got the job done in a timely manner. Wipers working perfectly so far.. Hope everything will continue. Clauds was very professional. Did a very good job.

Excellent Rating

(23)

Rating Summary

23

0

0

0

0

23

0

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

Windshield Laws in Tennessee

If If you drive on the roadways in Tennessee, you are already familiar with the traffic laws you must follow. In addition to the road rules, motorists are also required to make sure their vehicles are in compliance with the...

What Is the Difference Between a Water-Cooled Engine and an Air-Cooled Engine?

There There are a few main differences between a water-cooled and air-cooled engine. Air-cooled engines utilize an engine cylinder design that incorporates cooling fins all the way around the cylinder and on top of the piston cylinder head. These fins...

Symptoms of a Bad or Failing Low Water Sensor

If your car has low coolant without a warning, the Coolant Light comes on for no reason, or the car is overheating, replace the low water sensor.

how to fill slave cylinder

In order to pump up the clutch you need to fill the clutch master cylinder with brake fluid (https://www.yourmechanic.com/article/how-to-add-brake-fluid-to-your-car-by-toby-schultz). Have an assistant push the clutch to the floor several times while the clutch is held open with the bleed screw...

Potential electrical issue? Already replaced alternator and battery.

Hi there. I understand how frustrating things like this can be. I don't think you have any serious underlying electrical problems with the car. What I believe may be happening is simply a case of bad luck with aftermarket parts;...

Why is TPMS reading 0 psi after tire replacement and all sensors are functional

It's unclear if the sensor on the wheel where the tire ran flat was replaced as well. Running the tire flat could have damaged that sensor; and, a damaged sensor is indeed the most likely cause of the symptom that...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com