BMW 550i xDrive Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(6)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(6)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a BMW 550i xDrive Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2015 BMW 550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2016 BMW 550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2013 BMW 550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2014 BMW 550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2012 BMW 550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2011 BMW 550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example BMW 550i xDrive Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(6)

Rating Summary
6
0
0
0
0
6
0
0
0
0

Deward

17 years of experience
62 reviews
Deward
17 years of experience
BMW 550i xDrive V8-4.4L Turbo - Door Lock Actuator Replacement (Driver Side Front) - Jamestown, North Carolina
I am very pleased with the service provided on my vehicle. Mr. Jarrell arrived on time as scheduled and did a fantastic job replacing the Door Lock Actuator, answered all questions, very knowledgeable and helpful.

Kwante

12 years of experience
49 reviews
Kwante
12 years of experience
BMW 550i xDrive V8-4.4L Turbo - Coolant is leaking - Baltimore, Maryland
Excellent work! Very timely, knew what he was doing, and was quick and to the point. Glad I now have a go-to mechanic! Thanks, Kwante!

Junior

26 years of experience
69 reviews
Junior
26 years of experience
BMW 550i xDrive V8-4.4L Turbo - Heater Blower Motor - Fort Lauderdale, Florida
Junior changed out heater fan on my BMW 550i. He was clean and consiencious and did good job.

Blissel

4 years of experience
38 reviews
Blissel
4 years of experience
BMW 550i xDrive V8-4.4L Turbo - Oil Change - Hollywood, Florida
This was my first time using this service and I must say it was very convenient. Blissel was very professional and thorough with his work. He completed all services and answered every question I had. I will definitely use this service again for any of my vehicle needs.

Excellent Rating

(6)

Rating Summary
6
0
0
0
0
6
0
0
0
0
Number of BMW 550i xDrive services completed
66+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1100+
experts on our platform

Recent articles & questions

The Traveler’s Guide to Driving in Aruba
Aruba Aruba is probably best known for the beautiful weather and the stunning Caribbean beaches that beckon you to sit on the sand and let your worries melt away. However, the island has a number of other wonderful attractions and...
P0795 OBD-II Trouble Code: Pressure Control Solenoid C
P0795 means that a fault with the electronic pressure control solenoid, or the solenoid circuit, has occurred due to a faulty solenoid, or low fluid.
P0913 OBD-II Trouble Code: Gate Select Actuator Circuit High
P0913 means the transmission gate select actuator circuit is malfunctioning, most likely a result of faulty wiring.

AC blowing hot air after engine replacement

It sounds like your air conditioning has lost a charge. The refrigerant may have leaked, or they may not have charged the AC when they replaced the engine. I would have a technician come out and inspect your entire AC...

car suddenly won't start but radio and lights work, repair shop can't find problem

For the vehicle to start, many different systems must work. The most common causes of no-start conditions are the battery, starter, battery cable, ignition switch, or the fuel pump. Any of these can be intermittent issues, which will not always...

Put a new ecm in and no start

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com