Showing articles & questions for topic
V8-6.4L

Hi Anthony. Thanks for contacting us today. In most cases, a hard to start issue after completing wholesale changes is caused by something very simple - such as a loose or damaged ground wire to the coil, distributor or other...

Hi Karon. Thanks for contacting us tonight. 116,000 miles for any vehicle that is less than six-years-old is quite a bit. However, as long as it has been properly serviced, not involved in accidents or driven exceptionally hard, it could...

If you can select all other gears but 2nd, then the issue is likely to be internal to the transmission (as opposed to the clutch). To be sure, the external shift mechanism should be inspected but if that checks out,...

The oil pump in your transmission is probably worn out. The oil pump produces the hydraulic pressure that the transmission uses to engage the forward clutch. As the transmission warms up and some of the clearances tighten up, there is...

Hi there: In most newer trucks, like your 2014 Ram, if an error light is triggered and the repairs are made, you'll have to clear those stored error codes in the ECU with a digital scanner or they will stay...

Hello there, under all driving condition your 2013 Dodge Charger, the temperature should not rise outside normal operating temperatures. If the engine is getting hot during acceleration, then there is likely a problem. The most common faults would be a...

The excessive fuel condition is from the exhaust regeneration system malfunctioning and should be diagnosed following updated diagnostic procedures for the check engine codes received. Follow technical service bulletin 09-10-02 for an updated procedures directive.

Backfiring (https://www.yourmechanic.com/article/what-causes-a-car-to-backfire) is often caused by a too lean or too rich air-to-fuel ratio although a few other causes are discussed below. A backfire in the intake manifold is caused by a ratio that is too lean (not enough fuel)....

The noise is probably a consequence of an improper installation of the aftermarket parts and/or the parts are incompatible (inappropriate) for the vehicle design. Generally speaking aftermarket replacement parts are less desirable than OEM parts. Once you start installing vehicle...

Hi there. Typically when you have oil pressure issues like this, it is due to one of two common causes. Either the oil pump or oil pump sensor is faulty or you have an obstruction inside the filter. Since you...

Hi...Diagnostic Trouble Code P0016 (https://www.yourmechanic.com/article/p0016-obd-ii-trouble-code-camshaft-position-a-camshaft-position-correlation-bank-1-by-jay-safford) has many causes other than a failed camshaft position sensor. Other possible causes for Code P0016(https://www.yourmechanic.com/article/p0016-obd-ii-trouble-code-camshaft-position-a-camshaft-position-correlation-bank-1-by-jay-safford) to set include: the camshaft timing is wrong because the timing chain jumped teeth; the camshaft phaser is out...

Hi there. In most cases, when you experience a severe shake and vibration all of the sudden it's actually caused by road conditions. If the shake and vibration went away and has not returned while driving the same speed, you...

Hi there, thanks for writing in. This thunking noise is a common problem when U-joints (driveshaft) are worn out (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-universal-joint-u-joint). I would recommend having them inspected to be sure they do not have too much play in them. When there...

I would only be speculating on this problem since you have altered the fuel tank system on the truck. I suspect that the fuel pump is getting starved of fuel and when you are going up a hill causes the...