Showing articles & questions for topic
V6-3.0L Turbo Diesel

It takes a lot of battery to turn a diesel, so if your battery voltage is not 12.6, you need to charge or replace the battery. I don't recommend jump starting the car, because the electrical system may develop problems...

Hi there - unfortunately, this is not a service YourMechanic can offer at this time. Thanks for thinking of us though!

I am working on this

Hi there. You can disable the airbag to the vehicle. either the airbag is mechanical or electronic. If the airbag is electronic, when a child is sitting on the seat, the airbag light that says airbag ON, will now say...

Hi there: To be completely honest, there could be multiple issues with your 2008 Mercedes-Benz that are causing the symptoms you're describing, ranging from something simple like a crankshaft position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor) to the throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement) or complex...

Hi there. Check the glow plug control relay to see if it is malfunctioning. This is a common part to fail on the diesel engines. The light is coming on for a the computer seeing that the engine is too...

Hello. Typically this is not an issue with the relay. There have been some issues with the programming within the control computer that causes the fan to not work right which will cause this code. Being that the vehicle is...

The white smoke is a bit worrisome - usually an indicator of a blown headgasket, which will also cause rough running, especially at low speeds from a compression imbalance. The throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement) may also be sending "off" signals...

It sounds to me like the latching mechanism isn't doing its job properly, probably requiring replacement. I would have a certified mechanic, such as one from YourMechanic, verify the issue and replace the latch (https://www.yourmechanic.com/services/trunk-latch-replacement) if necessary.

If you are getting a pulsation in the brakes when applied at high speeds then you most likely have warped front brake rotors or they have hot spots on them that cause the pulsation. Inspect rotors and look for discolored...

Hello, thank you for writing in. To start, the generator is the alternator. It generates the power supply for the vehicle based off the vehicle's engine performance. There are several ways to approach the repair. You may remove the starter...

If the crack in the housing is in the plastic part, that can be written off to normal wear and tear. The plastic filter holder gets brittle and cracks easily. Most shops keep them on hand in case this happens...

Hello. There are several ways that you can accomplish painting just one panel. It really depends on your level of experience and how you feel most comfortable performing the task. You can start by removing the entire panel if you...

Hi there. It would seem to be the right front wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) that is making the noise. The vibration could be from the drive shaft center support bearing being worn out. To check if the bearing is worn, push...

Hi there. Thanks for writing in. In some cases, the oil leaking from the vehicle after a rear main seal and oil cooler are repaired is caused by residual oil that was not cleaned or removed from the vehicle after...

The Audi Q5 has an AdBlue filler cap located next to the fuel filler cap on the side of the car. Some Audis are supplied with a hexagonal AdBlue filler cap, which requires the wheel nut wrench from the boot....

The dealer would like to change the rotors to help prevent any come backs due to bad brake performance, vibrations, etc. It is not always necessary to replace the rotors, but if there is damage to them, like deep scoring,...

It sounds like the cable for the hood release has broken. These cables usually break at the connector under the dash. If this is the case, you can still open the hood; just find where the cable connects, and pull...