Showing articles & questions for topic
P0335

Hello. If the trouble codes have remained after the crankshaft position sensor has been replaced then it may be possible that the issue lies elsewhere. P0335 is the trouble code for a crank position sensor malfunction. The circuit includes the...

Hi there: The crankshaft position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor) on a six-cylinder Jeep Wrangler is going to be located behind the front motor plate, next to the timing chain/belt. Sometimes, however, the P0335 OBD-II error code (https://www.yourmechanic.com/article/p0335-obd-ii-trouble-code-crankshaft-position-sensor-a-circuit-malfunction-by-spencer-clayton) is not indicating the crank...

Hello. The crankshaft position sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) will not cause a fluctuation in the speedometer gauge. It can affect the rpm gauge, but not the speedometer. If the speedometer is acting like this then most of the time this is caused...

Those codes: P0170 (https://www.yourmechanic.com/article/p0170-obd-ii-trouble-code-fuel-trim-malfunction-bank-1-by-andrew-quinn), P0173 (https://www.yourmechanic.com/article/p0173-obd-ii-trouble-code-fuel-trim-malfunction-bank-2-by-blake-griffin), and P0335 (https://www.yourmechanic.com/article/p0335-obd-ii-trouble-code-crankshaft-position-sensor-a-circuit-malfunction-by-spencer-clayton) are indicating that the airflow coming in that is read by the MAF sensor to set up fuel injection timing does not match what the oxygen sensors are reading based on...

Hello. Your crankshaft position sensor has failed. Most engines support a fall-back mode where engine timing is then determined by the cam position sensor. It is less precise than when the crank position sensor is used, but allows the engine...

Hi there. Your vehicle shutting down while driving, after replacing a faulty CKP (crankshaft position sensor) and the ECM (engine control module) recognizing a P0335 circuit malfunction, leads me to believe the replacement CKP sensor may be faulty (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement). Sometimes,...

Hello. Cleaning the throttle body and idle valve may have been needed, but the intermittent starting and dying symptom can be the camshaft (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) and crankshaft sensors (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement). These are the codes P0335 (https://www.yourmechanic.com/article/p0335-obd-ii-trouble-code-crankshaft-position-sensor-a-circuit-malfunction-by-spencer-clayton) and P0340 (https://www.yourmechanic.com/article/p0340-obd-ii-trouble-code-camshaft-position-sensor-circuit-malfunction-by-jamahl-walker). The code P0446...