Showing articles & questions for topic
LR3

Hello. This could be caused by a variety of things. It could be that your spark plugs or coil packs are misfiring. This means that the coil pack is not sending the proper electricity to the spark plug. It could...

Hi there. If the code is for P0011 (https://www.yourmechanic.com/article/p0011-obd-ii-trouble-code-camshaft-position-a-timing-over-advanced-or-system-performance-bank-1-by-jay-safford), then there is an issue with the VVTi system. The Variable Valve Timing solenoids (https://www.yourmechanic.com/services/variable-valve-timing-vvt-solenoid-replacement) are not functioning properly. First change the engine oil and filter. Then clear the codes by...

Hey there, thanks for writing in about your 2006 Land Rover LR3. Unfortunately, this is a specialized service only available through Land Rover service centers, and not a cost estimate readily available to us here at YourMechanic. I recommend requesting...

It would be recommended not to drive the vehicle until it is looked at by a certified mechanic. If the [idler pulley])(https://www.yourmechanic.com/services/idler-pulley-replacement) were to fail, the drive belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement) would be unable to spin the water pump (https://www.yourmechanic.com/services/water-pump-replacement) and cause...

Hello there. It sounds like you have a few different malfunctions going on. The most serious would be the leak from the sunroof (https://www.yourmechanic.com/services/clear-fluid-is-leaking-inspection). The most likely cause is the sunroof seal or a failed sunroof assembly. With this leak...

Hi there. This is not an uncommon fault. The most likely causes would be low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service), a shift solenoid (https://www.yourmechanic.com/services/downshift-solenoid-replacement), transmission mounts (https://www.yourmechanic.com/services/engine-mount-replacement), or a drive shaft (https://www.yourmechanic.com/services/driveshaft-replacement). Your best bet may be to have a qualified professional,...

Hello. I would start by checking the engine oil level and pressure. Typically when this engine makes a noise like this it is due to a failure in one of the rod bearings or in the valve train. If the...

Hi there. The starter is located on the back of the engine on the driver side attached just in front of the transmission bell housing. You may have to remove the exhaust manifold to get to the starter. If you...

This may be related to a couple of different things. I would recommend checking the idle air control valve/module (https://www.yourmechanic.com/services/idle-control-valve-replacement) which works similar to the MAF sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) in that it regulates air intake as it is mixed with fuel...

This is a common fault that is found with vehicles that have air suspension. Though the compressors were most likely bad the first time, there is another problem causing them to fail. The most common would be a leak in...

When faults are intermittent such as this, they can be much harder to diagnose. Especially if they do not leave a code of some sort. A few different components can cause this fault. The most likely would be a fuel...