Showing articles & questions for topic
E-150

It is possible that the brakes may just need to be bled. Over time, brake fluid will absorb moisture out of the air. When the fluid absorbs too much moisture, the fluid is no longer able to effectively work, giving...

Hi there. I would recommend reading this article that is highlighted in blue. The P0175 OBD-II code (https://www.yourmechanic.com/article/p0175-obd-ii-trouble-code-p0175-system-too-rich-bank-2-by-blake-griffin) has multiple possible sources that can trigger the error code ranging from O2 sensors, mass air flow sensors or simply clogged fuel...

Hello Tom. P0420 (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) is the Catalyst System Efficiency Below Threshold (Bank 1) code. While there are a multitude of components that can cause this code, the general concept is that your catalytic converter is not working properly. If you...

The a/c compressor replacement (https://www.yourmechanic.com/services/ac-compressor-replacement) will not be the only component that will need to be replaced at the same time. The replacement of the compressor is about 1.5 hours and does not include the recover or evacuate and recharge...

Losing the ability to control the van in low wind speeds is an abnormal issue. There are a few faults that could cause this issue though. The most common would be low tire pressure (https://www.yourmechanic.com/article/how-to-check-your-tire-pressure), failing suspension component (https://www.yourmechanic.com/article/how-to-inspect-your-suspension-system), or...

Be careful of using some fuel additives. From my experience I've found some additives that will cause the fuel to boil in the heat. Also, depending on where you got your fuel, you may have got a "winter blend" of...

Hi. Cruise control systems only engage past about 35 mph, so make sure that is not the issue. Other issues that can sometimes interfere with the cruise control are brake lights that may be having connection issues. The system uses...

Hi...thank you for your question and I will try to help you with the issue. ALL faults that cause the check engine light to illuminate have to be resolved, with the light ultimately extinguished, because once the check engine light...

The noise is coming from the sway bar links, tie rod ends or lower ball joints. You will need to try and duplicate the noise without driving the vehicle and when noise is heard just put you hand on the...

A vibration while driving is generally caused by something that rotates with vehicle speed. A number of components can be the cause. An out of balance tire or tires, as well as an out of round tire (shifted belt) or...

With modern vehicles that have many electronic systems, it is not unusual for parts to quickly fail. In the past, mechanical parts would take awhile to fail and would generally let the users know something was wrong. Electrical parts, while...

A few different faults can cause a vibration while braking. The most common would be a warped brake disc (https://www.yourmechanic.com/services/brake-rotor-disc-replacement), faulty brake pads (https://www.yourmechanic.com/services/brake-pads-replacement), or the brake calipers (https://www.yourmechanic.com/services/brake-caliper-replacement). Excessive vibration when braking is not a normal operation of the...

Hello. Typically this occurs due to a bad vacuum check valve under the hood. During hard acceleration the AC door system loses vacuum, causing the doors to default to the windshield. This check valve keeps this from occurring. It is...