Showing articles & questions for topic
Aspen

Hi there, thanks for your question. Temperature gauge fluctuation could be due a faulty temperature gauge or a faulty thermostat (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-thermostat). If tested with a radar gun, this would be an external temperature source for testing the temperature, which would...

Hi there. First off, I strongly recommend NOT trying to clear codes by touching battery cables; as this is a quick way to fry the ECU as well. It is very possible that this action may have triggered your limp...

Hello. Most of the time when this noise occurs when you first start moving and gets louder as you drive it is due to a failure in one of the thrust bearings in the transmission. If the transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service)...

Without hearing the noise myself, it will be hard to make an accurate assessment for your 2008 Chrysler Aspen. In many cases, where the noise source is not obvious, chassis ears may need to be used to locate the source...

You may be able to get the powertrain control module reprogrammed to correct the issue on your 2007 Chrysler Aspen. This may be an issue where the transmission program is corrupt and an install of the latest software may correct...

In this case, you may need to have the wheels balanced on the vehicle if the tires have already been road force balanced. While tire balancing will result in a balanced tire and wheel assembly, it does not balance the...

Hi there. The code P2127 (https://www.yourmechanic.com/article/p2127-obd-ii-trouble-code-throttle-pedal-position-sensor-switch-e-circuit-low-by-spencer-clayton) is coming on for the throttle position sensor being disconnected or not communicating with the ECM (computer). Check the throttle position sensor to see if the resistance changes when the throttle is opened and...

You need to check the oil level to see how low you are on oil (https://www.yourmechanic.com/services/oil-level-is-low-inspection). You may not have added enough oil. If you are not sure then go to a full service station or have a technician, like...

The fault codes and engine operating/sensor information need to be looked at to see if there are any underlying issues. Fuel pressure and volume should be checked along with the induction system to make sure are no vacuum leaks present...

Hello, thanks for writing in about your 11998 Chrysler Aspen. If the MIL (Malfunction Indicator Lamp), also known as the Check Engine Light, is coming on, then there is a hard fault in the engine computer. This fault will need...