Showing articles & questions for topic
L6-3.5L

If your vehicle is equipped with a sun roof, then you may have a water leak due to the drains for the roof on both sides being blocked with dirt and debris. You may also have a blocked A/C drain...

I believe the "official" procedure for these M30 engines is to: Leave the tensioner until last Install the chain with the crank and cam sprockets on TDC, and the chain tight on the driver side of the chain Use the...

Hello. It sounds like the car has low battery voltage. Either the battery has gone bad (https://www.yourmechanic.com/services/battery-replacement) or the alternator is not charging (https://www.yourmechanic.com/services/alternator-replacement) properly and is draining the battery. I would suggest that you have the electrical system inspected...

Hello. If the engine will not crank at all and the starter and battery are fine then I start by checking to see if the starter relay is getting power (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-starter-relay). If it is but is not sending power to...

Hi There, It sounds like you may have a dirty or failing idle air control valve causing your engine idle to fluctuate and eventually stall. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) is a small valve on the engine's intake system...

Hello. It sounds like you may have a problem with the fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement) or other components of the fuel system. It is also possible that there is a problem with the battery (https://www.yourmechanic.com/services/battery-replacement) or other components of the electrical...

Hey there, thanks for writing in about your 1994 Chrysler New Yorker. Start your engine and let it idle in park for at least 5 minutes. Listen and check the engine for any vacuum leaks or inlet air tube leaks....

The noise would have to be heard to give a diagnosis for this. The noise may be coming from the brakes or suspension. The rack and pinion may be causing the issue but this would be difficult to determine without...